Eve Audio SC407 Manuel télécharger pdf (Page 8)

SC408

SC407

EVE Audio product manual

Mains Voltage Selector Speaker Positioning + Rubber Feet

14 15

OPERATION

POSITIONING

completely from the power grid. When powered o all settings are saved

and the power consumption is reduced to 0 watts.

After powering on again, the loudspeaker will return to the state it was

in before being turned o (Standby mode, Mute mode or a given volume

level). Even if powered o via a multiple outlet power strip, the monitor will

return to the state it was in before being turned o.

! In order to prevent switching noise with your monitoring system, keep in

mind the following rules:

Power all audio sources on rst and your loudspeakers last.

When turning o your system, power o your loudspeakers rst and then

all audio sources.

3.16. DIP Switches

On the rear panel of your EVE Audio monitors you will nd three DIP

Switches. These allow you to secure your loudspeaker settings to prevent

them from being changed inadvertently.

• Volume

When set to “lock,” this DIP Switch secures the current volume setting. The

LED ring on the front panel indicates the volume setting, but it cannot be

modied. When set to “variable,” the volume setting can be changed by

simply turning the knob.

• Filter

When set to “lock,” this DIP Switch secures the current lter settings. The

lter settings can be read on the LED ring, but they cannot be modied.

When set to “variable,” the lters can be modied freely.

• Not used

No Function.

• Max. Input

This DIP Switch determines the input sensitivity of the SC407 and SC408.

In a studio environment, the reference level (0dB) ought to be 4dBu. In

such environments, leave the setting at “+7dBu.” However, some studio

gear allow much higher output levels. If it were impossible to reduce the

output level of such devices, set the switch to “+22dBu.”

The “+7dBu” setting ought to be suitable for most situations.

3.17. Mains Voltage Selector

The Mains Voltage Selector allows you to adjust the operating voltage of

your EVE Audio monitors to the local power grid. Set it to “230” if your local

power grid is 220-240 volts or “115” if it is 110-120 volts.

If you change the mains voltage value you also have to replace the fuse of

the IEC connector with an appropriate one. The corresponding fuse values

are printed on the unit underneath the IEC connector.

3.18. Power Connector (IEC)

Use the power cord supplied to connect your EVE Audio monitors to the

power grid. The IEC connector includes an integrated fuse. If your EVE

Audio monitors stop working and the fuse seems to be the problem,

proceed as follows:

• Turn the loudspeaker o.

• Disconnect it from the power grid.

• Detach the IEC connector from the unit.

• Remove the fuse.

• Change the fuse. The replacement fuse should comply with the values

stated on the subwoofer.

4. POSITIONING

4.1. Speaker Positioning + Rubber Feet

Ideally, there should be no objects or obstacles between the loudspeakers

and the listening position. Furthermore, a symmetrical positioning is

important. This applies to the distance between speakers as well as to the

walls, ceiling and oor. In order to have a symmetrical stereo image it is

also important to have symmetrical reections. We recommend to keep

a distance of at least 0.5 m (19 inches) to the walls, in order to avoid low

frequency boosting.

EVE Audio monitors can also be ush-mounted in a wall, in which case

there should be enough air ow. This is important to keep the electronic

components cool but also to allow for the best performance of the bass

reex ports. We recommend to keep at least 3 cm (1 in) to the sides and

top.

The SC407 and SC408 monitors were designed to be placed vertically or

horizontally. The best position in each case will be determined by the room

and the system used. By default, your monitor is adjusted to be placed

horizontally. To use it in vertical position, turn the tweeter/mid-driver

section 90º. Follow the procedure indicated in the “Horizontal/Vertical

1 2 3 4 5 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire

Eve Audio SC407 Manuel Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Haut-parleurs de la barre de son Eve Audio SC407